Abstract
The method specified is based on determining the temperature at which a standard indenter, under a force of 50 N ± 1 N, penetrates 1 mm into the surface of a test piece cut from the wall of a pipe or fitting while the temperature is raised at a constant rate. Is applicable only to thermoplastics materials for which it is possible to measure the temperature at which the rate of softening becomes rapid. Is based on ISO 306:1994 which, however, applies to materials in the form of sheets.
General information
-
Status: PublishedPublication date: 1995-02Stage: International Standard to be revised [90.92]
-
Edition: 1Number of pages: 4
-
Technical Committee :ISO/TC 138/SC 5
- RSS updates
Read sample
Preview this standard in our Online Browsing Plateform (OBP)
Life cycle
-
Previously
WithdrawnISO 2507:1982
-
Now
-
Will be replaced by
Under developmentISO/WD 2507-1
Got a question?
Check out our FAQs
Customer care
+41 22 749 08 88
Opening hours:
Monday to Friday - 09:00-12:00, 14:00-17:00 (UTC+1)