ISO 16063-21:2003
p
ISO 16063-21:2003
27053
недоступно на русском языке
Текущий статус : Опубликовано (Hа стадии пересмотра)
Последний раз этот стандарт был пересмотрен в  2019. Поэтому данная версия остается актуальной
ru
Формат Язык
std 1 145 PDF
std 2 145 Бумажный
  • CHF145
Пересчитать швейцарские франки (CHF) в ваша валюта

Тезис

ISO 16063-21:2003 describes the calibration of rectilinear vibration transducers by comparison. Although it mainly describes calibration using direct comparison to a standard calibrated by primary methods, the methods described can be applied between other levels in the calibration hierarchy.

ISO 16063-21:2003 specifies procedures for performing calibrations of rectilinear vibration transducers by comparison in the frequency range from 0,4 Hz to 10 kHz. It is primarily intended for those who are required to meet ISO standardized methods for the measurement of vibration under laboratory conditions, where the uncertainty of measurement is relatively small. It can also be used under field conditions, where the uncertainty of measurement may be relatively large.

From knowledge of all significant sources of uncertainty affecting the calibration, the expanded uncertainty can be evaluated using the methods given in ISO 16063-21. It also covers the assessment of uncertainties for calibrations performed using a check standard.

Общая информация

  •  : Опубликовано
     : 2003-08
    : Подтверждение действия между-народного стандарта [90.93]
  •  : 1
  • ISO/TC 108
    17.160 
  • RSS обновления

Preview 

Предварительно ознакомьтесь с этим стандартом в нашем Он-лайн библиотека стандартов (OBP)

Жизненный цикл

Появились вопросы?

Ознакомьтесь с FAQ

Работа с клиентами
+41 22 749 08 88

Часы работы:
Понедельник – пятница: 09:00-12:00, 14:00-17:00 (UTC+1)