ISO 21903:2020

недоступно на русском языке

Тезис

This document specifies the metrological and technical requirements for flowmeters intended to be used for the dynamic measurement of liquefied natural gas (LNG) and other refrigerated hydrocarbon fluids. For LNG static volume measurement used in custody transfer, see ISO 10976.

This document sets the best practice for the proper selection and installation of flowmeters in cryogenic applications and identifies the specific issues that can affect the performance of the flowmeter in use.

Moreover, it offers a calibration guideline for laboratory and on-site conditions (mass or volume) by either using LNG or other reference fluids. The choice of calibration fluid will depend on the capabilities of the available flow calibration facilities and the ability to achieve the required overall measurement uncertainty demanded by the intended application.

This document is applicable, but is not limited, to the use of Coriolis and ultrasonic flowmeters for dynamic measurements of LNG.

In principle, LNG and other refrigerated liquid hydrocarbons are considered in this document. Recommendations in this document are based on the available test results with LNG. These results are probably applicable to other cryogenic fluids.

Общая информация

Текущий статус
: Опубликовано

Дата публикации
: 2020-02
Версия
: 1
Технический комитет
: ISO/TC 28 Petroleum and related products, fuels and lubricants from natural or synthetic sources
ICS
:
75.180.30 Volumetric equipment and measurements

Приобрести данный стандарт

	Формат	Язык
std 1 166	PDF
std 2 166	Бумажный

CHF166

Жизненный цикл

Сейчас

Опубликовано

ISO 21903:2020
Этап: 60.60

Данный стандарт разработан для достижения следующих Цель устойчивого развития

Недорогостоящая и чистая энергия

Появились вопросы?

Ознакомьтесь с FAQ

Работа с клиентами

+41 22 749 08 88

customerservice@iso.org

Часы работы:
Понедельник – пятница: 09:00-12:00, 14:00-17:00 (UTC+1)